Re-Anlalyzing Individual Loans

Re-Anlalyzing Individual Loans

Sometimes you might update loan information after you run the trial calculations of a loan. You can re-analyze individual loans so their analysis calculations are correct by using the Re-analyze Loan button on the Analysis screen.


Note: You cannot re-analyze loans in a final batch. Any loans that were not successfully calculated before you run the final update are deleted from the batch during the final update. Those loans are not updated.

To re-analyze an individual loan, complete these steps:

  1. Verify that the Analysis screen displays the analysis batch that includes the loans that you want to re-analyze.
  2. Select a loan, and then click Re-analyze Loan. Servicing Director re-analyzes the loan and displays a message when it is finished.

Note: If a message notifies you that the loan was not analyzed successfully, run the Unprocessed Loans report, correct any issues, and then try re-analyzing the loan.

  1. Click OK to close the message. The Analysis screen displays again.

ArticleNumber:

000044726

    • Related Articles

    • Re-analyzing an Individual Loan

      Sometimes you might update loan information after you run the trial calculations of a loan. You can re-analyze individual loans so their analysis calculations are correct by using the Re-analyze Loan button on the Analysis screen. Note: You cannot ...

    • Adding Loans to Investor Cutoffs

      Sometimes you need to add individual loans to cutoffs manually because you: Forgot to add a loan to a loan transfer batch Added a loan to a transfer batch but it has not posted yet, Added a loan to a loan transfer batch after the cutoff date for the ...

    • Investor Accounting Adding Loans to Loan Transfer Batches

      After you set up loan transfer batches on the Batch Setup screen, use the New Participant screen to add loans to loan transfer batches. Loan ownership is transferred when the loan transfer batch is posted. The New Participant screen displays the ...

    • Overview of Construction Loans

      To process construction loans in Servicing Director, you must first set up the system for construction loans as follows: Set up a company to allow construction loans. Set up cost codes and cost code templates. Set up inspections and assign the ...

    • Removing the payment cushion from the escrow analysis on a individual loan

      Removing the payment cushion from the escrow analysis on a individual loan To completely eliminate the calculation of a cushion on a individual loan, do the following Tracking>escrow info Analysis information>Payment cushion selected drop down>Select ...