Adding Counties to States or Regions

Adding Counties to States or Regions

After you set up states or regions, use the counties screen to add counties to the states or regions.

If you change a value for a county after set up, you can run the late charge prohibit update, the NSF fee update, and/or the late charge max/min update to change the loan-level county value to match the new county value. (If you are installing and setting up Servicing Director for the first time, it is not necessary to run these updates.)


Adding Counties to States or Regions:
  1. Access the system administration application.
  2. Select table setup.
  3. Select the state, region, and county from the list.
  4. Select open.
  5. Select a state or region that has counties that contain properties for the loans you service.
  6. Select counties.
  7. Select new, the New County Screen appears. The IRS code field displays a code that the IRS uses to identify a state.
  8. Enter the HMDA code for the county in the code field.
  9. Enter the name of the county.
  10. If you register loans with MERS, enter the FIPS county code assigned to this county.
  11. Enter the recording fee charged by this county.
  12. Select Ok.
Note: You can change or delete a state or county from the state and county tale. Select the state or county from the list and then select edit to change the information, or delete to delete the selected state or county from the table. You cannot delete a state or county that is being used in a loan.
  1. Select Close.

ArticleNumber:

000048559